Epson ELPMB76 Käyttöohje
Lue alta 📖 käyttöohje suomeksi merkille Epson ELPMB76 (10 sivua) kategoriassa Beamer. Tämä opas oli hyödyllinen 2 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä
Sivu 1/10
User's Guide
ELPMB 84
Projector Stacking Frame Beta
V12H006AW0
email: info@euromet.com
EM 2 2500
Safety Precautions
DANGER
• Failure to comply with these safety precautions results in death or serious injury;
• ELECTRICAL SHOCK HAZARD! Always turn o, disconnect, and disengage all power
sources to the projector before servicing;
WARNING
Failure to comply with these safety precautions may result in serious injury.
• At least two qualied people should perform the installation procedure. Personal injury
and/or property damage can result from dropping or mishandling the projector;
• If mounting to ceiling studs, make sure that the mounting screws are anchored into the
center of the ceiling studs. Use of an edge- -edge stud nder is recommended; to
• Be aware of the mounting environment. If drilling and/or cutting into the mounting
surface, always make sure that there are no electrical wires in the wall;
• Do not install near sources of high heat. Do not install on a structure that is prone to
vibration, movement or chance of impact.
INSTALLATION SAFETY
KITE can only be used by skilled sta who also have the authorization to TRANSPORT,
INSTALL and ADJUST the projector in complete safety based on the necessary
knowledge and competence.
In order to avoid injuries, it is necessary to comply with the following safety rules:
• Use KITE with a projector or projector’s cage only in environments which are not
exposed to weather events.
• Make sure the projector is compatible with the cage on which it is tted, as using
incompatible projectors could cause serious damages and injuries.
• Do not place KITE on: unstable surfaces, walls or unsuitable structures.
• For STACKING, make sure all safety PINS are fastened with their safety locks, then
make sure all nuts are tightened correctly onto the threaded PINS.
• Do not mount KITE or the projector when people are standing underneath the
installation area.
• Always fasten KITE to the TRUSS with a steel safety cord using the specic eyelets:
in case of fault or failure, the cord must ensure the cage not to be falling down lower
than 5 cm.
• Please read the local rules and regulations to comply with any possible additional
safety rules for hanging loads.
• Before mounting the projectors on KITE, carefully read the user's manual for both
products.
• If the projector is equipped with an additional lens, make sure it is removed during
the installation process.
• At least 2 people are required to install KITE.
• To avoid any risks during assembly and disassembly process:
- Wear gloves, helmet and suitable safety shoes,
- Make sure the underlying area is cleared and free.
o Carefully follow the instructions described in the
manual for STACKING KITES.
o Do not stack more than 3 KITES on the oor and no
more than 2 hanging.
The supporting structures and their components must be certied to support the cage and
projector weight.
Tuotetiedot
| Merkki: | Epson |
| Kategoria: | Beamer |
| Malli: | ELPMB76 |
Tarvitsetko apua?
Jos tarvitset apua merkille Epson ELPMB76 esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Beamer Epson Käyttöohjeet
17 Lokakuuta 2024
17 Lokakuuta 2024
17 Lokakuuta 2024
17 Lokakuuta 2024
17 Lokakuuta 2024
17 Lokakuuta 2024
17 Lokakuuta 2024
17 Lokakuuta 2024
17 Lokakuuta 2024
17 Lokakuuta 2024
Beamer Käyttöohjeet
- Beamer Philips
- Beamer Kogan
- Beamer Sony
- Beamer Panasonic
- Beamer Casio
- Beamer Viewsonic
- Beamer Miroir
- Beamer Acer
- Beamer Beghelli
- Beamer Barco
- Beamer VAVA
- Beamer Vankyo
Viimeisimmät Beamer Käyttöohjeet
26 Lokakuuta 2024
23 Lokakuuta 2024
22 Lokakuuta 2024
22 Lokakuuta 2024
22 Lokakuuta 2024
22 Lokakuuta 2024
22 Lokakuuta 2024
22 Lokakuuta 2024
22 Lokakuuta 2024
22 Lokakuuta 2024