Monogram ZK1SN309NLH Käyttöohje

Monogram Jääkaappi ZK1SN309NLH

Lue alta 📖 käyttöohje suomeksi merkille Monogram ZK1SN309NLH (2 sivua) kategoriassa Jääkaappi. Tämä opas oli hyödyllinen 2 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä

Sivu 1/2
31-1000410 Rev. 1 11-19 GEA
Installation
Instructions
Stainless Steel
Door Panel Kit
Before you begin - Read these instructions completely
and carefully.
Note to Installer: Be sure to leave these instructions with
the Consumer.
Note to Consumer: Keep these instructions with your
Installation Instructions for future reference.
This kit provides for the installation of the Stainless Steel Door Panel Assemblies
Tools and Materials Required:
T20 and T30 Torx driver / bits
Instructions for this kit are also included in the full installation instructions included with the unit.
WARNING Tip Over Hazard.
These appliances are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions for
securing the appliance with the anti-tip system before
installing door panel kit.
WARNING Door Trim Pinch Point
Hazard
Improper installation can lead to a finger pinch point
hazard between the side door trim and the cabinets
when operating the door, especially with children.
To minimize this risk you must follow the installation
instructions for cabinet dimensions, trim assembly, and
door stop angle.
ZK1SN189NLH LH 18” STAINLESS STEEL DOOR PANEL
ZK1SN184NRH RH 18” STAINLESS STEEL DOOR PANEL
ZK1SN249NLH LH 24” STAINLESS STEEL DOOR PANEL
ZK1SN244NRH RH 24” STAINLESS STEEL DOOR PANEL
ZK1SN309NLH LH 30” STAINLESS STEEL DOOR PANEL
ZK1SN304NRH RH 30” STAINLESS STEEL DOOR PANEL
ZKSP1H1CNSS MINIMALIST HANDLE FOR STAINLESS STEEL PANELS ONLY
ZKSP1H1PNSS STATEMENT HANDLE FOR STAINLESS STEEL PANELS ONLY
Installation Instructions
INSTALL STAINLESS PANEL
Ŷ Remove bottom hinge cover and retain the 4 T30 Torx
screws for later installation.
Ŷ Open door to 90°. Slide the panel onto the door with
the panel brackets interlocking on top and bottom with
the door brackets (make sure not to slide the panel into
the cabinetry surround). Center the panel on the door,
then slowly close the door while watching to make sure
the panel does not contact the surrounding cabinetry.
Ŷ With the door fully closed, carefully slide the panel
towards the cabinetry with the goal gap of 1/8”.
Bottom
hinge
cover
T30 Torx
screws
Door
Bracket
Panel
Bracket Panel
1/8” gap
Cabintery
Surround
Overlay
Panel
FOLLOW THE REMAINDER OF THE STAINLESS DOOR
PANEL INSTALLATION INSTRUCTIONS IN THE UNIT
INSTALLATION INSTRUCTIONS TO ADJUST AND
SECURE THE DOOR PANEL.

Tuotetiedot

Merkki: Monogram
Kategoria: Jääkaappi
Malli: ZK1SN309NLH

Tarvitsetko apua?

Jos tarvitset apua merkille Monogram ZK1SN309NLH esitä kysymys alla ja muut käyttäjät vastaavat sinulle




Jääkaappi Monogram Käyttöohjeet

Jääkaappi Käyttöohjeet

Viimeisimmät Jääkaappi Käyttöohjeet