PAC IR-X Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille PAC IR-X (1 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 5 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä

Sivu 1/1
Pacic Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
techsupport@pac-audio.com • Voice: 714-835-3022 • Fax: 714-835-3233 • www.pac-audio.com
Pacic Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
techsupport@pac-audio.com • Voice: 714-835-3022 • Fax: 714-835-3233 • www.pac-audio.com
IR-X Infrared Remote Repeater Installation Instructions 8-15-03
Control remote mounted / hidden video players and stereos using the units IR remote*.
* note: The IR remote being used must use a 40kHz or 56kHz carrier
frequency. Consult with equipment manufacture to determine the carrier
frequency. Check website for known units that do not work.
Special Features:
Easy 2 wire hook up
Extra long plug-in wire for remote IR
LED
Red LED ashes for conrmation of
wireless remote operation (red LED
will be dim when ashing)
Small and easy to mount
40kHz and 56kHz operation
Black receiver
(Round dimple must
face wireless remote)
Clear emitter on 1/8" plug
(round dimple must face device)
1. Connect Red wire to 12 volts accessory (switched power)
2. Connect Black wire is vehicle ground (negative)
3. Mount IR receiver (on the end of the short black wire) with the
round dome side facing out where it is in range / sight of the
remote control.
4. Mount IR LED (on the end of black wire with 1/8” plug) in front
of the unit/s to be controlled. The IR LED is directional, so
make sure the dimple on the side of the clear IR LED is facing
the unit being controlled. It can be taped to the front of the
unit or mounted in a location that can be seen by two or more
units to be controlled.
5. By leaving the brown wire of the IR-X disconnected and
insulated, it will transmit at a 40kHz IR signal, which is used
for most applications.
-or-
When the brown wire is connected to vehicle ground
(negative) the IR-X will transmit at a 56kHz IR signal which
is used in fewer applications. Ground the brown wire if only
the control response is slower than normal or is intermittent.
Installation Instructions
IR-X Infrared Remote Repeater Installation Instructions 8-15-03
Control remote mounted / hidden video players and stereos using the units IR remote*.
* note: The IR remote being used must use a 40kHz or 56kHz carrier
frequency. Consult with equipment manufacture to determine the carrier
frequency. Check website for known units that do not work.
Special Features:
Easy 2 wire hook up
Extra long plug-in wire for remote IR
LED
Red LED ashes for conrmation of
wireless remote operation (red LED
will be dim when ashing)
Small and easy to mount
40kHz and 56kHz operation
Black receiver
(Round dimple must
face wireless remote)
Clear emitter on 1/8" plug
(round dimple must face device)
1. Connect Red wire to 12 volts accessory (switched power)
2. Connect Black wire is vehicle ground (negative)
3. Mount IR receiver (on the end of the short black wire) with the
round dome side facing out where it is in range / sight of the
remote control.
4. Mount IR LED (on the end of black wire with 1/8” plug) in front
of the unit/s to be controlled. The IR LED is directional, so
make sure the dimple on the side of the clear IR LED is facing
the unit being controlled. It can be taped to the front of the
unit or mounted in a location that can be seen by two or more
units to be controlled.
5. By leaving the brown wire of the IR-X disconnected and
insulated, it will transmit at a 40kHz IR signal, which is used
for most applications.
-or-
When the brown wire is connected to vehicle ground
(negative) the IR-X will transmit at a 56kHz IR signal which
is used in fewer applications. Ground the brown wire if only
the control response is slower than normal or is intermittent.
Installation Instructions

Tuotetiedot

Merkki: PAC
Kategoria: Ei luokiteltu
Malli: IR-X

Tarvitsetko apua?

Jos tarvitset apua merkille PAC IR-X esitä kysymys alla ja muut käyttäjät vastaavat sinulle




Ei luokiteltu PAC Käyttöohjeet

PAC

PAC AOEM-GM1416A Käyttöohje

15 Lokakuuta 2024
PAC

PAC SR-TUN14H Käyttöohje

15 Lokakuuta 2024
PAC

PAC AOEM-HON20 Käyttöohje

15 Lokakuuta 2024
PAC

PAC TVC104 Käyttöohje

15 Lokakuuta 2024
PAC

PAC CDK651 Käyttöohje

15 Lokakuuta 2024
PAC

PAC MAZATO Käyttöohje

15 Lokakuuta 2024
PAC

PAC AOEM-GM21C Käyttöohje

15 Lokakuuta 2024
PAC

PAC APSUB-TY12 Käyttöohje

15 Lokakuuta 2024
PAC

PAC LPGL-2 Käyttöohje

15 Lokakuuta 2024
PAC

PAC GMK403 Käyttöohje

15 Lokakuuta 2024

Ei luokiteltu Käyttöohjeet

Viimeisimmät Ei luokiteltu Käyttöohjeet