Whirlpool DSCX 80113 Käyttöohje
Whirlpool
Kuivausrumpu
DSCX 80113
Lue alta 📖 käyttöohje suomeksi merkille Whirlpool DSCX 80113 (8 sivua) kategoriassa Kuivausrumpu. Tämä opas oli hyödyllinen 5 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä
Sivu 1/8
1
EN
1. On/O button (Reset if long
pressed)
2. Programme button (Water
conductivity setting if long
pressed)
3. Cycle end alert
4. Key lock
5. Steam option
6. Knob (Turn to select / Press to
conrm)
7. Start delay
8. Drying time
9. Dryness level
10. Options button
11. Start / Pause button
12. Display
13. Programmes area
CONTROL PANEL
1. Worktop
2. Control panel
3. Water tank
4. Door
5. Door handle
6. Door lter (behind door)
7. Bottom lter (behind ap)
8. Adjustable feet (4)
Before using the appliance carefully read the
Health and Safety guide.
DAILY REFERENCE
GUIDE
PRODUCT DESCRIPTION
APPLIANCE
1. 2. 7.3. 8.
12.
4. 9.5. 10. 11.6.
13.
3.
5. 4.
2.
1.
6.
7.
8.
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance,
please register your appliance on http://www.whirlpool.eu/register
2
Make sure that no lighters
or matches remain in the
laundry.
Make sure that the laundry
is not soaked with
ammable liquids.
DAILY USE
FIRST TIME USE
BEFORE USING THE DRYER
CHECK DRAIN HOSE AND WATER TANK
Make sure that the drain hose on the back of the dryer is xed
correctly, either to the dryer’s water tank (see picture), or to your
domestic sewage system (see Installation guide).
Also make sure that the water tank is correctly inserted.
See Use and Care Guide for more details on functions /
see last page for information on how to obtain the Use and Care Guide
1. LOAD LAUNDRY
Prepare your laundry according to the recommendations in
section .HINTS AND TIPS
Make sure that pockets are empty, fasteners closed and
ribbons tied together.
Open the door and load the laundry. Observe the
maximum load sizes given in the PROGRAMME CHART.
2. CLOSE DOOR
Make sure that no laundry gets stuck between door glass
and door lter.
Close the door so that you can hear it click shut.
3. SWITCH ON DRYER
Press the « until the programme button lights On/O button
up. An animation occurs, and there is a sound. Afterwards
the dryer is ready to be operated.
4. SET THE DESIRED PROGRAMME
GUIDED MODE – the button light will guide you through
setting your programme in the following order: selection of
programme / drying time (ONLY if Drying time or Airing
programme is selected) / dryness level (only if selectable /
adjustable) / options. As soon as you conrm a selection by
pressing the knob, the button light will jump to the next
step.
Select programme:
Make sure that the « lights up. Programme button
Turn the knob to select the desired programme.
The indicator next to the selected programme lights up.
Conrm the desired programme by pressing the knob.
1 2
Find more information regarding programmes in the
PROGRAMME CHART.
Select Drying time, if needed
Only if you have selected programme Drying time or Airing «,
you can set the desired drying time from a minimum of 10
minutes to maximum 180 minutes (three hours).
Make sure that the lights up. Drying time button
WARNING
3
EN
Turn the knob to select the desired drying time. Conrm it
by pressing the knob.
Set dryness level, if needed
If you want to change the dryness level, make sure that the
Dryness level button « lights up.
Turn the knob to select the desired dryness level, then press
the knob to conrm.
Select options, if needed
If you want to select additional options, make sure that the
Options button « lights up. The options which are selectable
for your programme are indicated by lighting arrows.
Turn the knob to select the desired options. The symbol of
the selected option will blink. To conrm it, press the knob.
Some options / functions can be selected by directly
pressing the button.
Refer to section OPTIONS, FUNCTIONS AND
INDICATORS for more information.
INDIVIDUAL MODE
After you have switched on the dryer, you are not forced to
follow the .GUIDED MODE
It is up to you which order you choose to set your
programme. To do a setting, rst press the relevant button,
then turn the knob to select, and nally press the knob to
conrm.
The variety of options and dryness levels depends on the
programme selected. Therefore it is recommended to start
your setting with selecting the programme.
5. START PROGRAMME
Press and hold « until the button lights up Start/Pause
solidly; the drying process starts.
The duration can be recalculated and adapted in the course
of the programme.
During such phases, an animation occurs on the display.
6. CHANGE THE SETTINGS OF A RUNNING
PROGRAMME, IF NEEDED
You can still change some settings after a programme was
started:
• Adjust drying time (only if programme Drying time is
selected)
• Add or cancel an option, provided the progress of the
programme still allows it.
Press the relevant button. The selected setting will blink for
a few seconds.
While blinking, you can adjust the setting by turning the
knob. If the value or setting stopped blinking, press the
button again.
Press the knob to conrm the modication. If you do not
conrm, the modication will be conrmed automatically
— the modied setting will stop blinking.
The programme will continue automatically.
To change the settings of a running programme or start
delay, you can also:
• press Start/Pause to put the running programme on pause
• change your settings
• press Start/Pause again to continue the programme.
7. RESET A RUNNING PROGRAMME, IF NEEDED
Press and hold the « until “rES” appears on On/O button
the display.
The programme is ended afterwards.
Immediately open the door and unload the laundry, so that
eventual heat in the laundry can dissipate.
8. SWITCH OFF THE DRYER AFTER PROGRAMME END
At the end of the programme, „End“ appears on the
display. Press « to switch o the dryer. Open the On/O
door and take out your laundry.
The dryer will switch o automatically in about a quarter of
an hour after programme end, to save energy.
9. EMPTY WATER TANK / CLEAN DOOR FILTER /
CLEAN BOTTOM FILTER
Refer to section CARE AND MAINTENANCE.
Tuotetiedot
| Merkki: | Whirlpool |
| Kategoria: | Kuivausrumpu |
| Malli: | DSCX 80113 |
Tarvitsetko apua?
Jos tarvitset apua merkille Whirlpool DSCX 80113 esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Kuivausrumpu Whirlpool Käyttöohjeet
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
Kuivausrumpu Käyttöohjeet
- Kuivausrumpu Maytag
- Kuivausrumpu Haier
- Kuivausrumpu Bosch
- Kuivausrumpu BEKO
- Kuivausrumpu Grundig
- Kuivausrumpu Electrolux
- Kuivausrumpu Siemens
- Kuivausrumpu Arcelik
- Kuivausrumpu Smeg
- Kuivausrumpu Hoover
- Kuivausrumpu AEG
- Kuivausrumpu Kogan
- Kuivausrumpu Candy
- Kuivausrumpu Gemini
- Kuivausrumpu Panasonic
- Kuivausrumpu Hyundai
- Kuivausrumpu Ufesa
- Kuivausrumpu Blaupunkt
- Kuivausrumpu Eldom
- Kuivausrumpu Philco
- Kuivausrumpu Becken
- Kuivausrumpu Heinner
- Kuivausrumpu Gaggenau
- Kuivausrumpu Zerowatt
- Kuivausrumpu Otsein-Hoover
- Kuivausrumpu Baumatic
- Kuivausrumpu Iberna
- Kuivausrumpu KDK
Viimeisimmät Kuivausrumpu Käyttöohjeet
26 Lokakuuta 2024
25 Lokakuuta 2024
25 Lokakuuta 2024
24 Lokakuuta 2024
24 Lokakuuta 2024
24 Lokakuuta 2024
24 Lokakuuta 2024
24 Lokakuuta 2024
24 Lokakuuta 2024
24 Lokakuuta 2024