Ampeg SVT-210AV Käyttöohje

Ampeg Ei luokiteltu SVT-210AV

Lue alta 📖 käyttöohje suomeksi merkille Ampeg SVT-210AV (4 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 3 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä

Sivu 1/4
Owner’s Manual
SVT 210AV
Speaker Cabinet
SVT 210AV Speaker Cabinet
2
Introduction
Congratulations!
You are now the proud owner of an Ampeg SVT 210AV speaker cabinet. This
cabinet has been designed to follow the classical good looks and features of our renowned
SVT-Series cabinets.
The SVT 210AV speaker cabinet is designed as an ideal companion to the Micro-VR amplifier
head, available separately.
Like all Ampeg products, your SVT 210AV cabinet is designed by musicians and built using
only the best of components. Each cabinet is tested to confirm that it meets our specifica-
tions, and we believe that this cabinet is the absolute best that it can be.
In order to get the most out of your new cabinet, please read this manual before you begin
playing.
And thank you for choosing Ampeg.
Here are some of the features packed into your new Ampeg SVT 210AV speaker cabinet:
Detailed 1970s-era SVT series appearance
Designed as a stack with the Micro-VR amplifier (available separately)
Foot cups on the top panel allow secure stacking of a Micro-VR amplifier
or up to four empty shot glasses.
Two ten-inch Eminence speakers
Two 1/4” TS parallel input and output jacks
Nominal impedance 8 ohms
Power handling 200 W RMS
Stylish top handle.
Important Safety Instructions
1. Read, follow, and keep these instructions. Heed all warnings.
2. This speaker is capable of producing high sound pressure levels that may cause permanent
hearing damage. User caution is advised and ear protection is recommended during use.
3. This speaker is designed for use on a sturdy, level surface. Whenever stacking speaker cabi-
nets, do not stack more than two high.
4. Speaker cables are a tripping hazard and must be routed out of traffic areas and away from any
possible accidental contact.
5. Do not expose this speaker to rain or moisture. Do not place liquid filled containers on this
speaker. Clean only with a dry cloth.
6. Repair or service of this speaker should be performed only by qualified personnel.
Micro-VR and
SVT 210AV
Stack
SVT 210AV Speaker Cabinet
3
System Block Diagram
1. 1/4" TS Input and Output Jacks: Connect the speaker-level output of your amplifier
(rated up to 200W into 8 ohms) to the input jack using good quality (non-shielded) speak-
er cable. Never use (shielded) instrument cable to connect speakers to an amplifier.
You can use the output jack to connect a second speaker cabinet in parallel. This will
present a total load of 4 ohms to the amplifier (maximum power input = 400 watts rms
into 4 ohms).
Rear Panel Connector Plate
1
From Power Amplier
+
10" EMINENCE
4 OHM SPEAKERS
TWO
PARALLEL
JACKS
+

Tuotetiedot

Merkki: Ampeg
Kategoria: Ei luokiteltu
Malli: SVT-210AV

Tarvitsetko apua?

Jos tarvitset apua merkille Ampeg SVT-210AV esitä kysymys alla ja muut käyttäjät vastaavat sinulle




Ei luokiteltu Ampeg Käyttöohjeet

Ei luokiteltu Käyttöohjeet

Viimeisimmät Ei luokiteltu Käyttöohjeet