AXESS AXGMLN-08 Käyttöohje

AXESS Ei luokiteltu AXGMLN-08

Lue alta 📖 käyttöohje suomeksi merkille AXESS AXGMLN-08 (8 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 3 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä

Sivu 1/8
Installation instructions for part AXGMLN-08
REV. 5/6/2020 INSTAXGMLN-08
axxessinterfaces.com metraonline.com © COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
Axxess Integrate
CAUTION!
All accessories, switches, climate controls panels, and
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
• Provides accessory power
(12-volt 10-amp)
• Retains R.A.P. (retained
accessory power)
Provides NAV outputs (parking
brake, reverse, and speed sense)
• Retains chimes
• Retains OnStar/OE Bluetooth
• Adjustable OnStar level
• Designed for non-amplified
models, or when bypassing
a factory amp
• Retains balance and fade
• AXUSB-CBL updatable
(sold separately)
INTERFACE FEATURES
Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
TOOLS REQUIRED
AXGMLN-08
GM Data Interface
2012-2016
APPLICATIONS
AXGMLN-08 interface • AXGMLN-08 harness
• 16-pin harness with stripped leads
INTERFACE COMPONENTS
Connections to be made 2 ...................................................
Installing the AXGMLN-08 3 ................................................
Initializing the AXGMLN-08 3 ..............................................
Adjusting the AXGMLN-08 3 ................................................
Table of Contents
CHEVROLET
Avalanche † * 2012-2013
Express 2013-2015
Malibu (with single color,
monochrome
display) * 2013-2015
Malibu Limited (
with single color,
monochrome display) * 2016
CHEVROLET (CONT)
Silverado 2500/3500 † * 2014
Silverado † * 2012-2013
Suburban † * 2012-2014
Tahoe † * 2012-2014
Trax * 2015-2016
GMC
Savana † 2013-2015
Sierra 2500/3500 † * 2014
Sierra † * 2012-2013
Yukon/Yukon XL † * 2012-2014
* These vehicles have an amplifier option. Please reference the “Service Parts Identification” sticker located in the
glove box for the RPO code UQ7 or Y91. If UQ7 or Y91 are present, then the vehicle is equipped with an amplifier.
Either use the AXGMLN-07 interface, or bypass the amplifier.
† Only for models with NAV.
AXGMLN-08
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the wire to the accessory wire.Red
Note: If installing an AXSWC (sold separately), there will be an accessory wire
there to connect as well.
• If the aftermarket radio has an illumination wire, connect the Orange/White
wire to it.
• If the aftermarket radio has a mute wire, connect the wire to it. If the Brown
mute wire is not connected, the radio will turn off when OnStar is activated.
• Connect the wire to the right front positive speaker output.Gray
• Connect the wire to the right front negative speaker output.Gray/Black
• Connect the wire to the left front positive speaker output.White
• Connect the wire to the left front negative speaker output.White/Black
The following (3) wires are only for multimedia/navigation radios that require
these wires.
• Connect the wire to the VSS/speed sense wire.Blue/Pink
• Connect the wire to the reverse wire.Green/Purple
• Connect the wire to the parking brake wireLight Green
From the AXGMLN-08 harness to the aftermarket radio:
• Connect the wire to the ground wire.Black
• Connect the Yellow wire to the battery wire.
• Connect the wire to the left rear positive speaker output.Green
• Connect the wire to the left rear negative speaker output.Green/Black
• Connect the wire to the right rear positive speaker output.Purple
• Connect the wire to the right rear negative output.Purple/Black
The Black/Yellow wire is used for OnStar level adjustment for models that
do not come equipped with steering wheel controls. Refer to the OnStar level
Adjustment section for further instructions.
12-pin pre-wired AXSWC harness:
• This harness is to be used along with the optional AXSWC (not included) to
retain steering wheel audio controls. If the AXSWC is not being used, disregard
this harness. If it will be used, please refer to the AXSWC instructions for radio
connections and programming.
Note: Disregard the harness that comes with the AXSWC.
• Connect the wire to the accessory wire.Red
Note: The relay attached to the AXGMLN-08 harness is only for audible turn
signal clicks. No extra steps are required to retain this feature, so leave the
relay as-is.
Connections to be made
AXGMLN-08
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the AXGMLN-08 harness,
into the interface.
• Connect the AXGMLN-08 harness to the wiring harness in the vehicle.
Note: If using the AXSWC, connect it after you initialize and test the
AXGMLN-08, with the key in the off position.
OnStar Level Adjustment
• Press the OnStar button to activate it.
• While OnStar is speaking, press the VOLUME UP or VOLUME DOWN button on
the steering wheel to raise or lower the OnStar level.
• If the vehicle does not come equipped with steering wheel controls, locate the
Black/Yellow
wire on the AXGMLN-08 harness.
While OnStar is speaking, tap the Black/Yellow wire to ground. Once the OnStar level
is set, it will stay at that level until the Black/Yellow wire is tapped to ground again
.
Attention! If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an AXSWC connect it after you initialize and
test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation, before reassembling the dash.
Initializing the AXGMLN-08
Installing the AXGMLN-08 Adjusting the AXGMLN-08

Tuotetiedot

Merkki: AXESS
Kategoria: Ei luokiteltu
Malli: AXGMLN-08

Tarvitsetko apua?

Jos tarvitset apua merkille AXESS AXGMLN-08 esitä kysymys alla ja muut käyttäjät vastaavat sinulle




Ei luokiteltu AXESS Käyttöohjeet

AXESS

AXESS AXDSPX-BM1 Käyttöohje

25 Lokakuuta 2024
AXESS

AXESS AXDIS-BW122 Käyttöohje

15 Lokakuuta 2024
AXESS

AXESS 99-3303 Käyttöohje

15 Lokakuuta 2024
AXESS

AXESS AXBT-MZ2 Käyttöohje

15 Lokakuuta 2024
AXESS

AXESS AX-ALOC618 Käyttöohje

15 Lokakuuta 2024
AXESS

AXESS ANC-GMH3 Käyttöohje

15 Lokakuuta 2024
AXESS

AXESS ANC-GMH2 Käyttöohje

15 Lokakuuta 2024
AXESS

AXESS ANC-CHH2 Käyttöohje

15 Lokakuuta 2024
AXESS

AXESS AX-AB-CH3 Käyttöohje

15 Lokakuuta 2024
AXESS

AXESS AX-AB-CH4 Käyttöohje

15 Lokakuuta 2024

Ei luokiteltu Käyttöohjeet

Viimeisimmät Ei luokiteltu Käyttöohjeet