Da-Lite Model C With CSR Käyttöohje
Da-Lite
Projektioruutu
Model C With CSR
Lue alta 📖 käyttöohje suomeksi merkille Da-Lite Model C With CSR (8 sivua) kategoriassa Projektioruutu. Tämä opas oli hyödyllinen 2 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä
Sivu 1/8
INSTRUCTION BOOK FOR
Model C With CSR
(Controlled Screen Return)
2
Installation
For Wall
Use No. 6 Brackets
To Hang Behind
Beam or Valance
Figure 1
For Ceiling
Screen may be mounted on a wall, suspended from ceiling or
extension brackets. Wall screens must be mounted level and with
the case-back parallel to the wall.
Wall Mounting
1. Select fasteners of proper type for wall or ceiling involved.
2. Insert fasteners through proper openings provided in back side
of end caps. See igure 1.
NOTE: DO NOT over tighten fasteners or damage may occur.
3. Attach screen securely to studding or other solid surface - never
to plaster only.
4. MAKE SURE SCREEN IS MOUNTED LEVEL.
Ceiling Mounting
1. Heavy screw hooks may be installed into wood joists. Other
types of hooks or chain may be used for other ceilings or for
stage installations.
2. Insert hooks or chain through proper openings provided in sides
of end caps. Screen must hang so that lat back of case is
perpendicular to loor.
NOTE: DO NOT hang from the end caps at an angle. See Figure
3. Must be perpendicular to the mounting See Figure 4.
3. MAKE SURE SCREEN IS MOUNTED LEVEL.
Figure 2
Figure 3
Figure 4
3
Troubleshooting
Symptom Cause
Solution
(96" wide and under)
Solution
(Over 96" wide)
Screen is retracting too slowly.
Over 8 seconds retracting from
the bottom into the case.
The CSR adjustment is not
correct.
See adjust retraction speed
section.
Retract screen completely, and then rotate
CSR shaft 1/2 turn at a time counterclockwise.
Screen is retracting too fast.
Under 3 seconds retracting
from the bottom into the case.
The CSR adjustment is not
correct.
See adjust retraction speed
section.
Retract screen completely, and then rotate
CSR shaft 1/2 turn at a time clockwise.
Screen is retracting too slowly,
and then slams the case when
adjusted counterclockwise.
The CSR unit (shock
absorber) is too strong.
Reset the CSR unit. Call Da-Lite (8006223737)
for detailed instructions.
Screen does not retract.
Retraction procedure*. Pull the screen down, and then retract irmly and quickly.
The CSR has been over
adjusted counterclockwise.
Turn adjustment
knob one quarter turn
counterclockwise.
The CSR unit is jammed. Reset or replace
the CSR unit. Call Da-Lite (8006223737) for
detailed instructions.
The roller tube is bent and
binding. Replace the screen.
Screen does not stay down.
Locking procedure. Pull the screen down, and then slowly
retract until it locks.
Dog is not locking. Retract screen completely, and then rotate
CSR shaft 1/2 turn counterclockwise.
To Lower Picture Surface
Pull screen down all the way. HESITATE – then allow screen to
retract VERY SLOWLY until it locks in place.
To Raise Picture Surface
Pull down on the pull bail, then release quickly. The screen will
retract gently into the case.
To Adjust Retraction Speed (Screens 96" Wide and Under)
Use a large lat screwdriver to turn the adjustment knob on the
right end of the screen (Figure 5). To increase the travel speed
turn counterclockwise. To decrease the travel speed turn
clockwise. Adjustments should be made in half turn increments
and travel speed checked before adjusting further.
NOTE: This feature is not available on some large screen sizes.
Call the factory for adjustment instructions.
Large picture surfaces are heavy and will start up too slowly to
prevent the locking dog from catching unless help is provided,
so keep picture surface moving briskly.
Should the locking dog catch, pull the picture surface down
about 4 inches and start the surface up rapidly.
Operating Instructions
Figure 5
Tuotetiedot
Merkki: | Da-Lite |
Kategoria: | Projektioruutu |
Malli: | Model C With CSR |
Tarvitsetko apua?
Jos tarvitset apua merkille Da-Lite Model C With CSR esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Projektioruutu Da-Lite Käyttöohjeet
16 Lokakuuta 2024
Da-Lite Käyttöohjeet
16 Lokakuuta 2024