ET2 Alumilux E41540-SA Käyttöohje

ET2 Helpotus Alumilux E41540-SA

Lue alta 📖 käyttöohje suomeksi merkille ET2 Alumilux E41540-SA (2 sivua) kategoriassa Helpotus. Tämä opas oli hyödyllinen 8 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä

Sivu 1/2
C o n t e m p o r a r y
L i g h t i n g
PRODUCT NAME: Alumilux
ITEM NUMBER: E41540-SA / E41540-WT
Please consult your electrician for hanging fixture and wiring.
MADE IN CHINA
Page 1 of (2)
To prevent water intrusion, caulk around back-plate
where fixture meets the wall using outdoor silicone
sealant. Leave a small gap at the bottom to allow
moisture to exit.
WARNING: Wires need to be connected to driver found
in canopy and should not be connected directly to
power source or a short may occur.
IMPORTANT: Turn off the power at the main fuse or circuit breaker box before starting installation
2.)
Page 2 of (2)
1.)
3.)
4.)
Clean with soft cloth and a mild detergent.
Do not use abrasive cleaner.
C
D
A
B
A
B
C
D
(A)
Backplate
(B)
Mounting bracket
(C)
Wire Nuts (x3)
(D)
Mounting screws (x2)
Step.4: Caulk around fixture with outdoor
silicone sealant to prevent water intrusion.
Leave a small gap at the bottom to allow
moisture to escape. Install fixture to back
plate (B) and tighten mounting screws (D)
to secure.
Step.1: Install Mounting bracket(A) to outlet box.
Step.2: Wire fixture to wires in outlet box.
Green/Copper wire is for Ground.
Step.3: Install Backplate(B) to Mounting
bracket(A).

Tuotetiedot

Merkki: ET2
Kategoria: Helpotus
Malli: Alumilux E41540-SA

Tarvitsetko apua?

Jos tarvitset apua merkille ET2 Alumilux E41540-SA esitä kysymys alla ja muut käyttäjät vastaavat sinulle




Helpotus ET2 Käyttöohjeet

Helpotus Käyttöohjeet

Viimeisimmät Helpotus Käyttöohjeet