ET2 Picolo E22271-75PC Käyttöohje

ET2 Lamppu Picolo E22271-75PC

Lue alta 📖 käyttöohje suomeksi merkille ET2 Picolo E22271-75PC (1 sivua) kategoriassa Lamppu. Tämä opas oli hyödyllinen 2 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä

Sivu 1/1
Installation Ins uctionstr
Model E PC22271-75
1. It is recommended the fixture be
installed by a qualified licensed
electrician.
2. Turn breaker off for circuit on outlet
where fixture is to be installed.
3. Install round mounting bracket to
outlet box.
4. Determine mounting height of
fixture and cut wire leaving an
additional 12” of extra wire for
wiring.
5. Thread wire through bottom of
decorative dome canopy and let slide
down wire to top of pendant.
6. Insert wire into bottom of mounting
cap and tie knot in cord on inside
cap for strain relief. Position
mounting cap to ceiling to check
mounting height. Adjust if
necessary.
7. Wire fixture to outlet. Connect
white to neutral and green to ground.
8. Install mounting cap to mounting
bracket and tighten cap nuts.
9. Move decorative canopy up wire to
meet ceiling and tighten screw on
bottom to secure.
Warning! This fixture is supplied with
permanently installed LED light engine.
The transformer for this light engine is not
dimmable. Do not use a dimmer on this
fixture or it will damage the transformer.
Using a dimmer voids the warranty of the
fixture.

Tuotetiedot

Merkki: ET2
Kategoria: Lamppu
Malli: Picolo E22271-75PC

Tarvitsetko apua?

Jos tarvitset apua merkille ET2 Picolo E22271-75PC esitä kysymys alla ja muut käyttäjät vastaavat sinulle