Hudson Valley KBS1752803-AGB/SWH Käyttöohje
Hudson Valley
Helpotus
KBS1752803-AGB/SWH
Lue alta 📖 käyttöohje suomeksi merkille Hudson Valley KBS1752803-AGB/SWH (2 sivua) kategoriassa Helpotus. Tämä opas oli hyödyllinen 2 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä
Sivu 1/2
SPLIT
KBS1752803
INSTALLATION INSTRUCTIONS
WARNING/CAUTION
DISCONNECT POWER BEFORE RE-LAMPING OR WIRING THE FIXTURE. READ ALL INSTRUCTIONS
COMPLETELY BEFORE STARTING INSTALLATION.
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL
APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES. THE INSTALLATION AND
MAINTENANCE OF THIS UNIT SHOULD BE COMPLETED BY A LICENSED ELECTRICIAN OR CERTIFIED
FACTORY TRAINED TECHNICIAN.
CALIFORNIA PROP 65: THIS LIGHTING FIXTURE CONTAINS CHEMICALS KNOWN TO THE STATE OF
CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS, AND/OR OTHER REPRODUCTIVE HARM. WASH HANDS
AFTER USE.
REMOVE THE FIXTURE, PARTS AND PARTS BAG(S) FROM THE CARTON. BEFORE DISCARDING THE
CARTON, DOUBLE CHECK TO MAKE CERTAIN THAT ALL PARTS ARE FOUND. INSPECT THE FIXTURE PRIOR
TO INSTALLATION FOR ANY DAMAGE TO THE FIXTURE.
DIMMING: THE FIXTURE CAN BE CONTROLLED BY A WALL DIMMING DEVICE. ONLY USE
TRIAC/ELECTRONIC DIMMER. MAKE SURE THE CARTON IS MARKED FOR USE WITH LED COMPACT
FLUORESCENT-INCANDESCENT LIGHT SOURCE ONLY. THESE CAN BE PROVIDED BY YOUR LOCAL
ELECTRICAL DISTRIBUTOR, HOME CENTER, OR HARDWARE STORE.
PLEASE CLEAN WITH A SOFT, DRY CLOTH ONLY! DO NOT USE CLEANSERS
www.hvlgroup.com
1
5
6
7
2
3
4
89
10
FIXTURE INSTALLATION
1. Attach the MOUNTING PLATE (1) unto the junction box using the MOUNTING SCREWS (2). This fixture is
designed to be mounted on standard round or octagon junction box. The junction box must be securely mounted
to the structure of the building.
2. Attach the Ground wire (Green) to the ground inside the outlet box (Generally green or bar copper wire) or the
GROUND SCREW (3) on the MOUNTING PLATE (1). NEVER CONNECT GROUND WIRE TO "HOT" WIRE!
FAILURE TO FOLLOW THIS COULD RESULT IN SERIOUS INJURY OR DEATH!
3. Connect the white fixture lead to the neutral (Generally white) wire in the outlet box. Fasten the wires together
with an approved fastener (WIRE NUT) (4). Starting 1" below the fastener, tightly wrap the connection with
electrical tape so that the connections seals the end of the fastener. MAKE SURE THERE ARE NO EXPOSED
WIRE OF STRANDS THAT COULD CAUSE A DANGEROUS SHORT CIRCUIT!
4. Connect the black fixture leads to the hot (Generally black) wire in the junction box. Fasten the joined wires
same as previous step. NEVER REVERSE HOT AND NEUTRAL WIRES. FAILURE TO FOLLOW THIS
COULD RESULT IN SERIOUS INJURY OR DEATH!
5. Attach the FIXTURE ASSEMBLY (6) to the MOUNTING PLATE (1) and secure with the BOLT NUT (5).
6. Adjust the ARMS (8) and SWIVEL (9) to the desired Angle.
7.
8.
Screw the BULB (7) up into the SOCKET of the fixture.THIS FIXTURE IS RATED FOR 60 WATT TYPE G25
LAMP. DO NOT EXCEED THE RECOMMENDED WATTAGE!
Restore power to the outlet at the breaker or fuse box.
.
ITEM DESCRIPTION PART NUMBER
1MOUNTING PLATE HDW-KBS1752803
2MOUNTING SCREW HDW-KBS1752803
3GROUND SCREW HDW-KBS1752803
4WIRE NUT HDW-KBS1752803
5BOLT NUT HDW-KBS1752803
6FIXTURE ASSEMBLY FAS-KBS1752803
7BULB NOT INLCUDED
8ARMS FAS-KBS1752803
9SWIVEL FAS-KBS1752803
10 RING RNG-KBS1752102
11 SHADE SHD-KBS1752102
FIXTURE INSTALLATION
1. Attach the MOUNTING PLATE (1) unto the junction box using the MOUNTING SCREWS (2). This fixture is
designed to be mounted on standard round or octagon junction box. The junction box must be securely mounted
to the structure of the building.
2. Attach the Ground wire (Green) to the ground inside the outlet box (Generally green or bar copper wire) or the
GROUND SCREW (3) on the MOUNTING PLATE (1). NEVER CONNECT GROUND WIRE TO "HOT" WIRE!
FAILURE TO FOLLOW THIS COULD RESULT IN SERIOUS INJURY OR DEATH!
3. Connect the white fixture lead to the neutral (Generally white) wire in the outlet box. Fasten the wires together
with an approved fastener (WIRE NUT) (4). Starting 1" below the fastener, tightly wrap the connection with
electrical tape so that the connections seals the end of the fastener. MAKE SURE THERE ARE NO EXPOSED
WIRE OF STRANDS THAT COULD CAUSE A DANGEROUS SHORT CIRCUIT!
4. Connect the black fixture leads to the hot (Generally black) wire in the junction box. Fasten the joined wires
same as previous step. NEVER REVERSE HOT AND NEUTRAL WIRES. FAILURE TO FOLLOW THIS
COULD RESULT IN SERIOUS INJURY OR DEATH!
5. Attach the FIXTURE ASSEMBLY (6) to the MOUNTING PLATE (1) and secure with the BOLT NUT (5).
6. Adjust the ARMS (8) and SWIVEL (9) to the desired Angle.
7.
8.
Screw the BULB (7) up into the SOCKET of the fixture.THIS FIXTURE IS RATED FOR 60 WATT TYPE G25
LAMP. DO NOT EXCEED THE RECOMMENDED WATTAGE!
Restore power to the outlet at the breaker or fuse box.
.
SPLIT
KBS1752803
INSTALLATION INSTRUCTIONS
www.hvlgroup.com
1
5
6
7
ITEM DESCRIPTION PART NUMBER
1MOUNTING PLATE HDW-KBS1752803
2MOUNTING SCREW HDW-KBS1752803
3GROUND SCREW HDW-KBS1752803
4WIRE NUT HDW-KBS1752803
5BOLT NUT HDW-KBS1752803
6FIXTURE ASSEMBLY FAS-KBS1752803
7BULB NOT INLCUDED
8ARMS FAS-KBS1752803
9SWIVEL FAS-KBS1752803
10
11
SHADE SHD-KBS1752102
2
3
4
89
ATTENTION PRUDENCE
DÉBRANCHEZ L'ALIMENTATION AVANT DE REMPLIR OU DE CÂBLER LE LUMINAIRE. LISEZ
COMPLÈTEMENT TOUTES LES INSTRUCTIONS AVANT DE COMMENCER L'INSTALLATION
POUR ÉVITER LE RISQUE D'INCENDIE OU D'ÉLECTROCUTION, LE LUMINAIRE DOIT ÊTRE INSTALLÉ
CONFORMÉMENT À TOUS LES CODES ÉLECTRIQUES/DE CONSTRUCTION NATIONAUX ET LOCAUX
APPLICABLES. L'INSTALLATION ET L'ENTRETIEN DE CET APPAREIL DOIVENT ÊTRE EFFECTUÉS PAR UN
ÉLECTRICIEN AGRÉÉ OU UN TECHNICIEN CERTIFIÉ FORMÉ EN USINE.
CALIFORNIE PROP 65 : CET APPAREIL D'ÉCLAIRAGE CONTIENT DES PRODUITS CHIMIQUES CONNUS PAR
L'ÉTAT DE CALIFORNIE POUR PROVOQUER LE CANCER, DES MALADIES CONGÉNITALES ET/OU D'AUTRES
DOMMAGES À LA REPRODUCTION. LAVER LES MAINS APRÈS UTILISATION.
RETIRER LE LUMINAIRE, LES PIÈCES ET LE(S) SAC(S) DE PIÈCES DU CARTON. AVANT DE JETER LE
CARTON, VÉRIFIEZ DOUBLE POUR VOUS ASSURER QUE TOUTES LES PIÈCES SONT TROUVÉES.
INSPECTER LE LUMINAIRE AVANT L'INSTALLATION POUR TOUT DOMMAGE AU LUMINAIRE.
GRADATION : LE LUMINAIRE PEUT ÊTRE CONTRLÉ PAR UN DISPOSITIF DE GRADATION MURALE. UTILISER
UNIQUEMENT UN GRADATEUR TRIAC/ÉLECTRONIQUE. ASSUREZ-VOUS QUE LE CARTON EST MARQUÉ
POUR UNE UTILISATION AVEC UNE SOURCE DE LUMIÈRE FLUORESCENTE À INCANDESCENTE COMPACTE
UNIQUEMENT. CEUX-CI PEUVENT ÊTRE FOURNIS PAR VOTRE DISTRIBUTEUR ÉLECTRIQUE LOCAL,
CENTRE À DOMICILE OU MAGASIN DE QUINCAILLERIE.
VEUILLEZ NETTOYER UNIQUEMENT AVEC UN CHIFFON DOUX ET SEC ! N'UTILISEZ PAS DE NETTOYANTS
Tuotetiedot
| Merkki: | Hudson Valley |
| Kategoria: | Helpotus |
| Malli: | KBS1752803-AGB/SWH |
Tarvitsetko apua?
Jos tarvitset apua merkille Hudson Valley KBS1752803-AGB/SWH esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Helpotus Hudson Valley Käyttöohjeet
3 Tammikuuta 2025
3 Tammikuuta 2025
3 Tammikuuta 2025
3 Tammikuuta 2025
3 Tammikuuta 2025
3 Tammikuuta 2025
3 Tammikuuta 2025
3 Tammikuuta 2025
3 Tammikuuta 2025
3 Tammikuuta 2025
Helpotus Käyttöohjeet
- Helpotus Stamos
- Helpotus ORNO
- Helpotus Ledlenser
- Helpotus DeWalt
- Helpotus Neewer
- Helpotus Philips
- Helpotus IKEA
- Helpotus Razer
- Helpotus Kogan
- Helpotus Behringer
- Helpotus GoGEN
- Helpotus Nitecore
- Helpotus Kichler
- Helpotus Integral LED
- Helpotus Golden Lighting
- Helpotus ET2
- Helpotus Quoizel
- Helpotus Crystorama
- Helpotus Brennenstuhl
- Helpotus Varaluz
- Helpotus FIAP
- Helpotus Aputure
- Helpotus Media-tech
- Helpotus Gemini
- Helpotus Dainolite
- Helpotus Tesy
- Helpotus EMOS
- Helpotus Sharper Image
- Helpotus Fluval
- Helpotus Ryobi
- Helpotus Nanlite
- Helpotus BeamZ
- Helpotus Maxim
- Helpotus Brandson
- Helpotus Aplic
- Helpotus NUVO
- Helpotus Milwaukee
- Helpotus OttLite
- Helpotus Showtec
- Helpotus V-Tac
- Helpotus Infinity
- Helpotus Nedis
- Helpotus Elation
- Helpotus Chauvet
- Helpotus Karma
- Helpotus TFA
- Helpotus Weeylite
- Helpotus Lumie
- Helpotus WAC Lighting
- Helpotus ESYLUX
- Helpotus Livarno Lux
- Helpotus Eurolite
- Helpotus Aqara
- Helpotus Beghelli
- Helpotus Middle Atlantic
- Helpotus Rosco
- Helpotus DeSisti
- Helpotus American DJ
- Helpotus Astera
- Helpotus EXO
- Helpotus Novy
- Helpotus Profoto
- Helpotus Claypaky
- Helpotus GRE
- Helpotus Ikan
- Helpotus Ring
- Helpotus Perel
- Helpotus Blackburn
- Helpotus Sigma
- Helpotus Rayzr 7
- Helpotus Excello
- Helpotus Vimar
- Helpotus Genaray
- Helpotus Altman
- Helpotus Kanlux
- Helpotus ARRI
- Helpotus Osram
- Helpotus Elan
- Helpotus Light4Me
- Helpotus Lume Cube
- Helpotus Digipower
- Helpotus Fiilex
- Helpotus Currey & Company
- Helpotus Kino Flo
- Helpotus Cateye
- Helpotus GVM
- Helpotus Wiesenfield
- Helpotus Angler
- Helpotus Raya
- Helpotus Dracast
- Helpotus ColorKey
- Helpotus Luxli
- Helpotus LUPO
- Helpotus Livex Lighting
- Helpotus Eglo
- Helpotus Hinkley Lighting
- Helpotus Ranex
- Helpotus COLBOR
- Helpotus Fuzzix
- Helpotus DMT
- Helpotus Sea&Sea
- Helpotus Lucide
- Helpotus Peerless-AV
- Helpotus Paulmann
- Helpotus HQ Power
- Helpotus Sagitter
- Helpotus Audibax
- Helpotus Triton Blue
- Helpotus Singercon
- Helpotus Forte Lighting
- Helpotus ETC
Viimeisimmät Helpotus Käyttöohjeet
6 Tammikuuta 2025
6 Tammikuuta 2025
6 Tammikuuta 2025
6 Tammikuuta 2025
6 Tammikuuta 2025
6 Tammikuuta 2025
6 Tammikuuta 2025
6 Tammikuuta 2025
6 Tammikuuta 2025
6 Tammikuuta 2025