Imarflex IHU-400 Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille Imarflex IHU-400 (4 sivua) kategoriassa Ilmankuivain. Tämä opas oli hyödyllinen 3 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä

Sivu 1/4
SPECIFICATION
MODEL NO. : IHU-4 00
RATED VOLTAGE : 230Va.c. ~ 60Hz
POWER CONSUMPTION : 18 wat ts
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed, including
the following:
1. Read all instructions carefully.
2. Before using the unit, check if the voltage indicated corresponds with the convenience outlet
(230Va.c.).
3. Do not use two-way socket with another appliance.
4. Do not use any appliance with a damaged cord or plug. If the cord is damaged it should be
replaced with the same type and size or bring the unit to the nearest authorized service center.
5. Do not place the unit near gas stove, electric stove or in a heated oven.
6. Put the unit on at stable surface; keep it away from the edge of counter to avoid accident.
7. Close supervision is necessary when any appliance is used by or near children.
8. To protect against electric shock, do not immerse the base in water.
9. Do not attempt to empty, ll and tilt the humidier while it is working.
10. Do not use the unit for outdoor use.
11. Do not use this unit other than its intended use.
12. For household use only.
13. Save this instruction for future reference.
DESCRIPTION OF PARTS
HOW TO USE
1. Lift the Water Tank and turn upside down.
2. Open the Water Tank Cover.
3. Fill the Water with water but not all the way to the water tank rim. Tank
4. on. Lock the Cover back
5. Check the Sound Eliminator inside the Base; make sure that it is tted. Do not remove it
while in use.
6. Turn the Water Tank upside down and return to the Base.
7. Plug the unit into the convenience outlet.
8. Turn the Mist Control Knob to the desired settin g.
9. After a few seconds mist will start emitting out of the Mist Nozzle.
10. Turn OFF after use.
NOTE: It is normal to hear a dripping sound when mist output is at a high level.
- As a safety feature, the Light Indicator will turn red and the mist will stop if the water
runs out in the humidier.
CLEANING AND MAINTENANCE
1. Unplug the unit from the convenience outlet before cleaning.
2. Wipe the base of the unit with damp cloth.
3. Do not use abrasive materials to avoid scratches.
How to Clean the Water Tank
1. Fill the water tank with water.
2. Put a mild detergent and then shake it well.
3. While shaking, hold it with both hands and do not hold it with the handle.
4. After shaking, remove the water and rinse it thoroughly.
NOTE: The water tank should be cleaned once a week.
How to Clean the Transducer & Water Basin
1. To remove the water residue, pour approximately 2 tbsp. of white vinegar and add water
into the water basin. Make sure it lls the entire water basin but not all the way to the rim.
2. one Allow the water with vinegar to soak for at least -half hour.
3. Brush the solution in the transducer and in the areas encrusted with water residue. Use
the brush provided by the unit or with soft bristled brush.
4. Discard the solution and rinse it thoroughly.
NOTE: Clean the Transducer & Water Basin at least once a month to remove the
accumulation of water residue.
REMINDER: Please do not forget to fill up and send the warranty card

Tuotetiedot

Merkki: Imarflex
Kategoria: Ilmankuivain
Malli: IHU-400

Tarvitsetko apua?

Jos tarvitset apua merkille Imarflex IHU-400 esitä kysymys alla ja muut käyttäjät vastaavat sinulle