Imarflex IWD-1050 Käyttöohje
Imarflex
Vedenannostelija
IWD-1050
Lue alta 📖 käyttöohje suomeksi merkille Imarflex IWD-1050 (4 sivua) kategoriassa Vedenannostelija. Tämä opas oli hyödyllinen 3 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä
Sivu 1/4
SPECIFICATION:
MODEL NO. : IWD- 1050
POWER CONSUMPTION : Hot –420W
Cold –100W
RATED VOLTAGE : 230Va.c. 60Hz
BOX DIMENSION : 340*370*1150mm
IMPORTANT SAFEGUARDS:
When using electrical appliances, basic safety precautions should always be followed, including the
following:
1. Read all instructions thoroughly.
2. Before using the Water Dispenser, check if the voltage indicated corresponds with the convenience
outlet (230Va.c.).
3. Do not use two-way socket with another iance. appl
4. Do not use any appliance with a damaged cord or plug. If the cord is damaged, it must be replaced
with the same type and size of a qualied person or bring the unit to the manufacturer or to the
nearest Imarex Authorized Service Center to avoid hazard.
5. To avoid a hazard due to instability of the appliance, it must be xed in accordance with the
instructions.
6. Do not place the Water Dispenser near gas stove, electric burner or heated oven.
7. Children should be supervised to ensure that they do not play with the appliance.
8. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliances by a person responsible for their safety.
9. Keep the water dispenser in a dry and cool place and avoid direct sunlight. Rearward of the
machine should be at least 20cm far from the wall. Never put the machine on the paper or foam,
which may cause unstable condition, such as store water or cause creepage. Never put anything
ammable beside this machine.
10. To avoid damage, do not plug the power cord or turn on the heating switch until 3 minutes after
you put the lled water gallon.
11. This water dispenser must be used with third-prong grounding plug and creepage protection switch.
If two at plugs will use, the grounding wire must be properly grounded before use.
12. In case the unit will not use for a long time, turn o the switch and pull the plug out from the socket
then drain the remaining water through drain hole.
13. Never use organic liquid to clean the machine. Splashing of water to the body is strictly prohibited.
14. You should use the ON/OFF switch to turn on or o the unit. It is prohibited to turn on or o the unit
through plugging or unplugging the power cord. Never extend the length of the power supply cord
to avoid re.
15. Never turn the machine upside down or lean it more than 45°.
16. Do not adjust the thermostat of the unit by yourself.
17. Power cord or other parts of the unit must be replaced by authorized service center personnel.
18. The cooling time of the unit might take longer when the environment temperature is higher than
the normal.
19. Save this instruction for future reference.
DESCRIPTION OF PARTS:
HOW TO USE:
1. Tear the label from the water gallon.
2. Turn the water gallon upside down then vertically insert the water gallon into the gallon supporter
on top of the machine.
3. Insert the plug to the socket; turn on the power switch located at the back portion of the unit. The
indicator lights up accordingly once the machine works.
4. Vertically pull out the water gallon by two hands when the gallon is empty and replace it with another
gallon of water.
5. The latest single tap can be tted for consumer’s taste; you can freely control the water temperature
by pressing the two taps at the same time.
CLEANING AND MAINTENANCE:
• Prepare bleach disinfecting solution
Mix 1 teaspoon (5ml) of household bleach with 1 liter of water. make this any stronger. If Do not
you make extra solution, this should be used up within 30 days. Safety note: Use vinegar instead
if you are sensitive to bleach
• Draining Instruction: Open the taps and take o the cap and rubber stopper from the water outlet
on the rear side of the unit
• Clean your water dispenser
1. Unplug the unit.
2. Remove the empty water gallon.
3. Remove no-spill top and/or bae if equipped.
4. Wearing gloves and safety goggles, scrub interior of reservoir and nozzle(s) with sponge
soaked in bleach solution. Let the solution stand for more than 2 minutes but less than 5
minutes to avoid plastic corrosion.
NUMBER
PART NAME
1
Gallon Supporter
2
Power Light Indicator
3
Hot Light Indicator
4
Cold Light Indicator
5
Cold Water Tap
6
Room Temp Water Tap
7
Hot Water Tap
8
Water Spout
9
Water Collector
10
Cold Switch
11
Hot Switch
12
Power Cord
13
Condenser
14
Drain Hole
Tuotetiedot
| Merkki: | Imarflex |
| Kategoria: | Vedenannostelija |
| Malli: | IWD-1050 |
Tarvitsetko apua?
Jos tarvitset apua merkille Imarflex IWD-1050 esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Vedenannostelija Imarflex Käyttöohjeet
20 Lokakuuta 2024
20 Lokakuuta 2024
20 Lokakuuta 2024
20 Lokakuuta 2024
20 Lokakuuta 2024
20 Lokakuuta 2024
20 Lokakuuta 2024
20 Lokakuuta 2024
Vedenannostelija Käyttöohjeet
Viimeisimmät Vedenannostelija Käyttöohjeet
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
18 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024