JL Audio Stealthbox SB-GM-SLVCRW/10TW3 Käyttöohje
Lue alta 📖 käyttöohje suomeksi merkille JL Audio Stealthbox SB-GM-SLVCRW/10TW3 (5 sivua) kategoriassa Subwoofer. Tämä opas oli hyödyllinen 2 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä
Sivu 1/5
I N S T A L L A T I O N G U I D E
for the
SB-GM-SLVCRW/10TW3
SKU# 94574
2001 - 2006 Chevrolet Silverado/GMC Sierra Crew Cab
2007 Crew Cab “Classic” Trucks
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system.
With proper installation, your new vehicle-specific enclosed subwoofer system
will deliver years of listening pleasure.
We strongly recommend that you have your new Stealthbox® installed by your authorized
JL Audio dealer. The installation professionals employed by your dealer have the necessary tools
and experience to disassemble and reassemble your vehicle properly. If you prefer to perform your
own installation, please read this installation guide completely before beginning the process.
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox ® be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
Continued on Next Page
SB-GM-SLVCRW/10TW3 INSTR_SKU# 011364
INS TALLATION
D I F F I C U L T Y :
25
OUT
OF
ESTIMATED TIME:
2 HOURS
S P E C I F I C A T I O N S
Enclosure Type: Sealed
Driver Type: 10TW3-D4 (x 2)
Nominal Impedance: 4 ohms
Continuous Power Handling: 800 watts (RMS method)
I N C L U D E D H A R D W A R E
(2) Large Bracket
(2) Small Bracket
(4) U-Nut
(2) 3/8 - 16 x 2-1/4” Set Screw
(2) 1/4” Spacer
(2) 1/4 - 20 x 1/2” Flange Bolt
(2) 1/4 -20 Flange Nut
(2) 3/8 - 16 x 3/4” Flange Bolt
(2) 3/8” Fender Washer
(2) 3/8” Lock Washer
(2) 3/8” Hex Nut
SB-GM-SLVCRW/10TW3 INSTR_SKU# 011364
P O W E R R E C O M M E N D A T I O N
JL Audio recommends high quality ampliers such as the JL Audio HD750/1. The diagram below shows the recommended crossover settings for the HD750/1. For a detailed description of the amplier settings, consult the
owner’s manual for the amplier. If another amplier is being used, please reference this illustration and use similar settings on that amplier.
C O N N E C T I O N S
Using quality power, signal, and speaker wire is essential in ensuring the performance of your Stealthbox®. JL Audio recommends using a 4 AWG power kit such as the XD-PCS4-1B for your Stealthbox® amplier. Other kits
are available should you be using more than one amplier. Signal wire such as the JL Audio Premium Audio Interconnect Cables should be used to provide signal for both channels of the amplier. JL Audio
reccomends using 12AWG speaker wire for subwoofers such as our XC-BCS12-25.
Continued on Next Page Page 2 • JL Audio, Inc., 2013
Continued on Next Page
SB-GM-SLVCRW/10TW3 INSTR_SKU# 011364
Page 4 • JL Audio, Inc., 2013
S T E P 4
Locate the two rectangular holes just outside the outer child
safety lock holes.
S T E P 8
Remove the U-Nut, and enlarge the pilot hole drilled in the
previous step to 9-16”. Use caution as to not hit the outer
cab wall.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a reduction
in your weekly pay.
Always wear eye protection when drilling!
S T E P 3
If equipped, remove the snaps that hold the top of the
carpet to the back of the cab.
S T E P 7
Using a 19/64” drill bit, drill a pilot hole into the back of the
cab through the U-Nut. Use caution as to not damage the
threads of the U-Nut or hit the outer cab wall.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a reduction
in your weekly pay.
Always wear eye protection when drilling!
S T E P 2
Carefully unclip and remove the upper plastic trim panel.
S T E P 6
Slide a U-Nut in backwards through the rectangular hole as
shown.
S T E P 1
Fold down the rear seats and empty the area behind them.
S T E P 5
In vehicles where the carpet covers these rectangular holes,
the carpet will need to be cut as shown.
Tuotetiedot
| Merkki: | JL Audio |
| Kategoria: | Subwoofer |
| Malli: | Stealthbox SB-GM-SLVCRW/10TW3 |
Tarvitsetko apua?
Jos tarvitset apua merkille JL Audio Stealthbox SB-GM-SLVCRW/10TW3 esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Subwoofer JL Audio Käyttöohjeet
12 Tammikuuta 2025
11 Tammikuuta 2025
29 Joulukuuta 2024
29 Joulukuuta 2024
29 Joulukuuta 2024
29 Joulukuuta 2024
8 Joulukuuta 2024
8 Joulukuuta 2024
8 Joulukuuta 2024
Subwoofer Käyttöohjeet
- Subwoofer Teufel
- Subwoofer Fender
- Subwoofer Axton
- Subwoofer Yamaha
- Subwoofer Pioneer
- Subwoofer Ecler
- Subwoofer KEF
- Subwoofer Pyle
- Subwoofer Kicker
- Subwoofer OSD Audio
- Subwoofer Kenwood
- Subwoofer Max
- Subwoofer Elac
- Subwoofer Yorkville
- Subwoofer JBL
- Subwoofer Infinity
- Subwoofer Helix
- Subwoofer Soundstream
- Subwoofer Klipsch
- Subwoofer Ground Zero
- Subwoofer Glemm
- Subwoofer Monitor Audio
- Subwoofer Canton
- Subwoofer PSB
- Subwoofer ESX
- Subwoofer Omnitronic
- Subwoofer Black Hydra
- Subwoofer Origin Acoustics
- Subwoofer Bazooka
- Subwoofer SVS
- Subwoofer Phoenix Gold
- Subwoofer Dynacord
- Subwoofer REL Acoustics
- Subwoofer Apart
- Subwoofer Hifonics
- Subwoofer Boston Acoustics
- Subwoofer AudioSource
- Subwoofer Taga Harmony
- Subwoofer ButtKicker
- Subwoofer Eve Audio
- Subwoofer Deaf Bonce
- Subwoofer Martin Audio
- Subwoofer Mackie
- Subwoofer Audibax
Viimeisimmät Subwoofer Käyttöohjeet
16 Tammikuuta 2025
14 Tammikuuta 2025
12 Tammikuuta 2025
12 Tammikuuta 2025
11 Tammikuuta 2025
11 Tammikuuta 2025
5 Tammikuuta 2025
5 Tammikuuta 2025
5 Tammikuuta 2025
5 Tammikuuta 2025