Kicker CX800.1 Käyttöohje
Kicker
Vastaanotin
CX800.1
Lue alta 📖 käyttöohje suomeksi merkille Kicker CX800.1 (28 sivua) kategoriassa Vastaanotin. Tämä opas oli hyödyllinen 3 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä
Sivu 1/28
CX
AMPLIFIERS
Owner’s Manual
CXA400.1 | CXA800.1
CXA1200.1 | CXA1800.1
Manual del Propietario | Español
AMPLIFICADOR DEL LA SERIE CX.1
Benutzerhandbuch | Deutsch
MONOVERSTÄRKER DER CX.1-SERIE
Manuel d’utilisation | Française
AMPLIFICATEUR DE SÉRIE CX.1
2019 CXA Mono Amps Rev H.indd 1
2019 CXA Mono Amps Rev H.indd 1
2019 CXA Mono Amps Rev H.indd 1
2019 CXA Mono Amps Rev H.indd 1
2019 CXA Mono Amps Rev H.indd 1 10/7/2019 2:33:32 PM
10/7/2019 2:33:32 PM
10/7/2019 2:33:32 PM
10/7/2019 2:33:32 PM
10/7/2019 2:33:32 PM
2
CX.1-SERIES AMPLIFIERS
OWNER’S MANUAL
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4” (10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill
four holes using a 7/64” (3mm) bit and use the supplied #8 screws to mount the amplifi er.
The KICKER CX Amplifi ers are capable of space-saving vertical mounting. Use a 2.5mm hex key (Allen wrench)
to loosen the end panel, remove the existing brackets, then insert and tighten the double-slotted brackets to the
amplifi er as illustrated on the next page.
PERFORMANCE
Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
MODEL: CXA400.1 | CXA800.1
CXA1200.1 | CXA1800.1
Model: CXA400.1 CXA800.1 CXA1200.1 CXA1800.1
RMS Power [Watts]
@ 14.4V, 4 mono, ≤ 1% THD+N
@ 14.4V, 2 mono, ≤ 1% THD+N
@ 14.4V, 1Ω mono, ≤ 1% THD+N
150W x 1
300W x 1
400W x 1
300W x 1
600W x 1
800W x 1
600W x 1
1200W x 1
1200W x 1
900W x 1
1800W x 1
1800W x 1
Length [in, cm] 8-1/8, 20.6 8-1/8, 20.6 12, 30.6 13-5/8, 34.6
Specifi cations common to all models:
Height [in, cm] 2-3/8, 5.9
Width [in, cm] 6-3/4, 17
Frequency Response [Hz] 25–200
Signal-to-Noise Ratio [dB] >95, A-weighted, re: rated power
Input Sensitivity Low Level: 125mV–5V
High Level: 1V–40V
Electronic Crossover Variable Lo-pass 50Hz–200Hz, 12dB/octave
KickEQ™ Bass Boost Variable 0–6dB @ 40Hz
Subsonic Filter 25Hz, 24dB/octave
Remote Bass Yes (sold separately)
WARNING: KICKER products are capable of producing sound levels that can permanently damage your hearing! Turning up a
system to a level that has audible distortion is more damaging to your ears than listening to an undistorted system at the same
volume level. The threshold of pain is always an indicator that the sound level is too loud and may permanently damage your
hearing. Please use common sense when controlling volume.
Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
NOTE: 2019 CXA mono amplifi ers are 1Ω stable - power rating +/- 10%.
2019 CXA Mono Amps Rev H.indd 2
2019 CXA Mono Amps Rev H.indd 2
2019 CXA Mono Amps Rev H.indd 2
2019 CXA Mono Amps Rev H.indd 2
2019 CXA Mono Amps Rev H.indd 2 10/7/2019 2:33:34 PM
10/7/2019 2:33:34 PM
10/7/2019 2:33:34 PM
10/7/2019 2:33:34 PM
10/7/2019 2:33:34 PM
3
Wiring: Disconnect the vehicle’s battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er. Make the ground wire short, 24” (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicle’s chassis. Adding an additional ground wire of this same gauge (or larger) between the
battery’s negative post and the vehicle chassis is recommended.
The CX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereo’s source unit. A high-level signal can be run from the source unit’s speaker outputs to the
stereo RCA input on the end panel of the amplifi er using the KICKER KISL as shown (make sure you set the CX
amplifi er’s input level switch to “HI”). Alternatively, the signal can be delivered to the amplifi er using the low-level
RCA outputs on the source unit. Set the input level switch on the end panel of the amplifi er to “LO”. Either input
method will provide an output signal at the RCA output, which effectively passes the audio signal to another
amplifi er or component. Keep the audio signal cable away from factory wiring harnesses and other power wiring.
If you need to cross this wiring, cross it at a 90 degree angle.
source unit
high-level speaker
outputs
to amplifi er
shield
double-slotted
bracket
+
–
core conductor
OR
VERTICAL MOUNTING
hex screws
amplifi er end panel
KICKER KISL (optional)
from source unit high-
level speaker outputs
to amplifi er
Install a fuse within 18” (45cm) of the battery and in-line with the power cable connected to your amplifi er. If you
ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the amplifi er--just the opposite as when you installed it.
2019 CXA Mono Amps Rev H.indd 3
2019 CXA Mono Amps Rev H.indd 3
2019 CXA Mono Amps Rev H.indd 3
2019 CXA Mono Amps Rev H.indd 3
2019 CXA Mono Amps Rev H.indd 3 10/7/2019 2:33:34 PM
10/7/2019 2:33:34 PM
10/7/2019 2:33:34 PM
10/7/2019 2:33:34 PM
10/7/2019 2:33:34 PM
Tuotetiedot
| Merkki: | Kicker |
| Kategoria: | Vastaanotin |
| Malli: | CX800.1 |
Tarvitsetko apua?
Jos tarvitset apua merkille Kicker CX800.1 esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Vastaanotin Kicker Käyttöohjeet
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
Vastaanotin Käyttöohjeet
- Vastaanotin Bosch
- Vastaanotin Jensen
- Vastaanotin Goobay
- Vastaanotin Kogan
- Vastaanotin Yamaha
- Vastaanotin Extron
- Vastaanotin Lindy
- Vastaanotin Ecler
- Vastaanotin AudioControl
- Vastaanotin Rotel
- Vastaanotin Auna
- Vastaanotin OSD Audio
- Vastaanotin Audizio
- Vastaanotin MB Quart
- Vastaanotin Aplic
- Vastaanotin Advance
- Vastaanotin Artsound
- Vastaanotin Denon
- Vastaanotin Helix
- Vastaanotin Soundstream
- Vastaanotin Rolls
- Vastaanotin Ground Zero
- Vastaanotin Glemm
- Vastaanotin EA
- Vastaanotin Match
- Vastaanotin Renkforce
- Vastaanotin Scansonic
- Vastaanotin Crunch
- Vastaanotin Peavey
- Vastaanotin Fosi Audio
- Vastaanotin Antelope Audio
- Vastaanotin Vaddio
- Vastaanotin ESX
- Vastaanotin Omnitronic
- Vastaanotin Russound
- Vastaanotin MEE Audio
- Vastaanotin GigaBlue
- Vastaanotin Mx Onda
- Vastaanotin Electro-Voice
- Vastaanotin Boss
- Vastaanotin JL Audio
- Vastaanotin Shanling
- Vastaanotin Atlas Sound
- Vastaanotin Memphis Audio
- Vastaanotin Primare
- Vastaanotin PureLink
- Vastaanotin Kramer
- Vastaanotin Yaesu
- Vastaanotin Musical Fidelity
- Vastaanotin RDL
- Vastaanotin Ferguson
- Vastaanotin REL Acoustics
Viimeisimmät Vastaanotin Käyttöohjeet
27 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024
26 Lokakuuta 2024