Ventev VenVolt 802.3at Käyttöohje
Lue alta 📖 käyttöohje suomeksi merkille Ventev VenVolt 802.3at (2 sivua) kategoriassa Accu. Tämä opas oli hyödyllinen 2 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä
Sivu 1/2
www.ventevinfra.com sales@ventev.com 800-851-4965
VenVolt™ 802.3at PoE+ Site Survey Battery Pack
Charging and Operations Guide
The VenVolt™ is an 802.3af/at compliant during Site Surveys. It can be battery for powering WiFi Access Points
operated either on its back (with the ethernet ports facing the right side of the unit) or on its side (with the ethernet
ports facing up). It supports ethernet pass-through for conguring devices or other ethernet IP connectivity
requirements you may think of (Meraki Cloud, gateway checking, iPerf, etc.). This Charging and Operations Guide will
familiarize you with the VenVolt’s features so you can be up-and-running in no time.
Performance: The VenVolt delivers over 6 hours of continuous run time using a fully powered Cisco 3802, with both
radios turned up to the max, 1 client associated to each radio, both sending trac to each other and to the AP. This is
expected to be a ‘worst case’ scenario, and any deviation from this is likely to produce run time improvements.
Display Gauge: The gauge on front the front cap is not a ‘battery charge’ gauge, but rather a ‘power output’ gauge.
Ventev recommends using the Voltage display when charging your VenVolt. Use the ‘Display Cycle’ button below
the gauge to change the display from Percentage to Voltage numbers for a better understanding of the charge
status.
Note: The gauge has three positions: Voltage, Percentage, and Blank. Simply press the ‘Display Cycle’ button
repeatedly to cycle through the various displays.
Charging: Charge your VenVolt before use. Charging typically takes 4-5 hours to recharge a fully discharged
battery. Ensure the wall charger is fully and securely plugged into the VenVolt’s charge port. When plugged in, and
at full capacity, the gauge should reect the maximum voltage of your AC adapter, indicating that the battery has
completed charging and the voltage from the charger is being fully passed through. Full charge capacity is either
just over 15V (for 15V chargers) or just over 18V (for 18V chargers). Both AC chargers/adapters are functionally
equivalent and fully interchangeable. The 15V or 18V readings indicate that the battery is ‘topped o’ and at 100%
capacity. When the charger is disconnected, the gauge will immediately drop to 13.4V (or so) to show available
voltage.
Operation: The voltage gauge will oat around 12V-13V during most of the day while in use. VenVolt follows a very
long discharge curve, then drops o dramatically (as indicated by the chart on the back of the unit). This rapid drop-
o is simply a characteristic of the LiFePo4 battery chemistry.
Normally, no more than a half-hour of useful power remains when volts start to fall o below 11V or so. This
should happen very late in the day during site surveys.
The VenVolt supports charging while being used. This means that you can simply roll up to an AC outlet, plug the
VenVolt in while it’s being used and it will take a trickle charge to keep your battery up!
At full capacity (noted above at a jump to 18.6V (or so), the VenVolt will shut o the injector to protect itself from
overcharging. Stated dierently, if you run the VenVolt plugged in, and powering an AP at the tippy-top of its
voltage curve, you run the risk of powering o your AP. If your battery discharge indicator is at 13.4V (or so), don’t
bother plugging it in to keep it topped o.
www.ventevinfra.com sales@ventev.com 800-851-4965
VenVolt™ 802.3at PoE+ Site Survey Battery Pack
Charging and Operations Guide
Additional Information:
The VenVolt is rated at 84WH and should be safe for carry-on and checked bags. If in doubt, carry the VenVolt with
you if you’re traveling on an airplane. The TSA recommends that the Master Power Switch be taped to the o
position during air travel.
Do not open/modify the VenVolt. This will void its warranty and you can compromise the power integrity (and
various discharge benets, longevity awesomeness, etc.) of the unit.
The USB port on the front will charge cell phones, etc. - and if you have a USB-C laptop/tablet, VenVolt can keep
your laptop/tablet charged during the day too!
Tuotetiedot
| Merkki: | Ventev |
| Kategoria: | Accu |
| Malli: | VenVolt 802.3at |
Tarvitsetko apua?
Jos tarvitset apua merkille Ventev VenVolt 802.3at esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Accu Ventev Käyttöohjeet
17 Lokakuuta 2024
Accu Käyttöohjeet
Viimeisimmät Accu Käyttöohjeet
27 Lokakuuta 2024
21 Lokakuuta 2024
21 Lokakuuta 2024
19 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
15 Lokakuuta 2024