Viking K-1275 Käyttöohje
Viking
Kulunvalvontajärjestelmä
K-1275
Lue alta 📖 käyttöohje suomeksi merkille Viking K-1275 (12 sivua) kategoriassa Kulunvalvontajärjestelmä. Tämä opas oli hyödyllinen 3 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä
Sivu 1/12
PRODUCT MANUAL
Designed, Manufactured and Supported in the USA
S E C U R I T Y & C O M M U N I C AT I O N S O L U T I O N S
Features
The K-1275 Entry Phone is a two-way, handsfree
telephone with 12 buttons for calling individual
residences in an apartment building with an
integrated 125 KHz Proximity Card Reader. It also
has a built-in color CCTV video camera. The
rugged stainless steel faceplate has a printed
directory housed in a waterproof, scratch-resistant
lens. Each button is beside the tenants name in the
directory so there are no confusing codes to deal
with. Calling a particular tenant is as easy as
pressing a single button. The has a built inK-1275
speed dialer that can handle up to 12 primary
phone numbers, each with 22 digits. If there is no
answer at the first number, a second number can
be called automatically. Once the tenant answers
their phone, a single touch tone command can
activate the door strike relay. For “no phone line”
applications, the is compatible with theK-1275
C-3000 no CO (phone line) controller.
The K-1275-EWP shares all of the features of the
K-1275 in addition to Enhanced Weather
Protection (EWP) for outdoor installations where
the unit is exposed to precipitation or
• Built-in high resolution analog NTSC color video camera with wide
viewing angle, tilt/swivel adjustments and wide operating
temperature: -40°F to 140°F
• Built-in 125KHz 26-bit Wiegand proximity card reader with LED, beep
card read confirmation, and EWP board protection
• Compatible with the following Viking Proximity Cards and Fobs: PRX-
C PRX-C-ISO PRX-FOB LRT-4 (DOD# 198 & 226), , and
• Vandal Resistant Features: 14 gauge louvered 316 stainless steel
faceplate with permanent laser etched graphics, heavy duty metal
keypad and T-10 Torx security mounting screws.
• Marine grade 316 stainless steelWeather Resistant Features:
faceplate and screws. Internally sealed keypad. Mylar speaker. Self-
draining mic mount. Faceplate, keypad, mic and speaker gaskets.
• Designed to meet IP66 Ingress Protection Rating (see )DOD 859
• Operates on 12 to 24 volts AC/DC
• 12 speed dial buttons (22 digits each)
• 12 alternate number positions (22 digits each)
• One button operation (no call button)
• Hang up on CPC, busy, silence, time-out or dial tone
• Touch tone restriction from microphone
• Integral relays for camera control and door strike
• Works with for increased securityC-1000B
• Works with for “No CO” (phone line) operationC-3000
• 50 keyless entry codes
• Postal lock input
• Optional surface mount box, sold separately ( )VE-5x10 DOD 424
• Small apartment buildings
• Professional buildings
• Gated communities
Power: 12 to 24 Volts AC or DC, 12VDC adapter provided
Proximity Card Reader Power: 5 to 14V DC @ 60mA maximum
Note: To assure operation during a power outage, a UPS
should be used.
Dimensions: 127mm x 254mm x 63.5mm (5" x 10" x 2.5")
Shipping weight: 2.2 kg (4.8 lbs.)
Standard K-1275 Environment: -34° C to 65° C (-30° F
to 150° F) with 5% to 95% non-condensing humidity
K-1275-EWP Environment: -34° C to 65° C (-30° F to
150° F) with up to 100% condensing humidity
Relay Contact Rating:
Door Strike: 5A @ 30VDC/250VAC maximum
Camera: 0.5A @ 125 VAC, 1.0A @ 30VDC
Connections: (19) gel-filled butt connectors (3M
Scotchlok UR2)
Applications
Specifications
www.vikingelectronics.com
Information: (715) 386-8861
VIKING
condensation. EWP products feature foam rubber
gaskets and boots, sealed connections, gel-filled
butt connectors, as well as urethane or thermal
plastic potted circuit boards with internally sealed,
field-adjustable trim pots and DIP switches for easy
on-site programming.
(shown in optional
VE-5x10-SS, not included)
12 Button Apartment Entry Phone with Built-In
Door Strike Relay, Card Reader & Camera
“Brushed 316 Stainless Steel”
(similar to brushed nickel)
K-1275 Series
Entry Phones with Keypads,
Proximity Card Readers
and Color Camera
July 5, 2017
Power: 5 to 14V DC @ 60mA maximum
Maximum Cable Length: 500 ft 24 Awg stranded shielded
(Belden 9537)
Frequency: 125KHz
Format: 26 bit Wiegand
Read Range: 1.25” to 2.0”
Technologies Supported: Viking , PRX-C PRX-C-ISO,
PRX-FOB LRT-4, , certain legacy HID® proximity protocols*
and certain AWID 125Khz proximity protocols**
Transducer: Beeps during card read
LED: Red, turns off during card read
Humidity: Up to 100% (fully potted EWP)
Operating Temperature: -34° C to 65° C (-30° F to 150° F)
* HID and the HID logo are registered trademarks of HID
Global Corporation, an ASSA ABLOY company. All other
trademarks are the property of their respective owners.
** AWID is a trademark of Applied Wireless Identification Group.
Power: 6-22V DC 150mA (12V DC UL Listed adapter included)
Image Sensor: 1/4” color CMOS
Video Output: 1 VP-P composite, NTSC, 75 ohms
Resolution: 420 lines (640 x 480 @ 30fps / 307,200 pixels)
Sensitivity: 0.025 LUX (50 IRE) F 1.2 3200K
Lens: 2.1mm, conical pinhole
FOV Field of View)( : 80° Horizontal, 60° Vertical, 100° Diagonal
Tilt/Swivel Adjustment: Vertical +/- 20°, horizontal +/- 30° (see
Diagram A)
IR Compatibility: This camera is equipped with an OLP
(Optical Low Pass) filter to maintain correct video color
in outside applications. The standard camera is NOT
compatible with IR illuminators. If IR illumination is
required, you will need to replace the exisiting camera
with a Viking model . For more information,VCAM-1IR
see .DOD# 190
Maximum Wire Run Length:1000 ft with *RG59/RG6 for video and
CAT5 for power (1 pair) and entry phone audio (1 pair). 150 ft with
CAT5E for video, power and entry phone audio (longer video runs
are possible by using video balun transceivers, see Installation
section , page D 4
* Note: RG59 or RG6 with solid center conductor and
95% bare copper braid shield.
Proximity Card Reader Specifications
Camera Specifications and Adjustments
Fea tures Overview
Keypad: Push to initiate call, push
again to disconnect. Zinc Die cast
with Satin Chrome Finish, internally
sealed per IP67.
Speaker Screen: Speaker screen
with 0.018" wide slots to prevent
punctures from paperclips, etc.
Faceplate Material: 14 gauge 316
stainless steel with #4 brushed
finish.
Speaker: Mylar speaker with
rubber gasket to maintain
water-tight seal and eliminate
water deterioration.
Blue Call LED: Lights steady to
help locate the button in low light,
flashes during dialing, then lights
steady when answered.
Microphone: Omni-directional
microphone with protective
water-resistant cloth.
Front View of the
K-1275 Entry Phone
Condensation Drain Hole
Mounting Screws: (8) 6-32 X 3/4”
Marine grade 316 stainless steel,
flat head, T-10 Torx security
screws and drive bit (included).
Laser Etched Graphics: For long
lasting easy to read graphics.
VIKING ©
#
*
0
9
8
7
6
5
4
3
2
1 2
3 4
56
7 8
9 0
#
*
Color Video Camera: Wide
operating temperature range of -40°F
to 140°F, NTSC composite video
output with 420 lines of resolution,
80° wide viewing angle lens, tilt and
swivel adjustments for aiming
towards visitors.
Protective Camera Window:
Impact resistant polycarbonate lens
with scratch resistant coating and
water-tight gasket.
Proximity Card Reader: 26-bit
Wiegand, 125KHz, red LED turns off
and transducer will beep during card
read. Fully potted EWP. Read range
1.25" to 2.0". Impact resistant
polycarbonate lens with water-tight
gasket.
Vertical (Tilt)
Adjustment
+/- 20 degrees
maximum
Horizontal (Rotation)
Adjustment
+/- 30 degrees maximum
2
80° Lens FOV
Rotate
Left 30°
Rotate
Right 30°
Camera Lens
Diagram A
Camera Horizontal Field of View:
Camera Adjustments:
The camera can be tilted and rotated to your desired
position. A portable service (test) monitor can be used
to determine the correct viewing angle during
installation.
Important: To prevent the edge of the faceplate from
being viewed in the video image, do not rotate the
camera beyond 30 degrees or tilt beyond 20 degrees.
Installation
IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from both the AC
outlet and the telephone line. It is recommended that a surge protector be installed to protect against such surges.
A. Mounting
VIKING
©
#
*
0
9
8
7
6
5
4
3
2
Optional VE-5x10 Surface Mount
Box (not included), see DOD# 424
10.0"
9.5"
4.50"
2.596"
5.00"
8.65"
0.425"0.952"
Front View
of the K-1275-IP
9.12"
2.5"
4.5"
Zinc-Plated Steel
Rough-In Box
(included)
Side View
of the K-1275-IP
(8) #6-32 x 3/4" Stainless
Steel, T-10 Torx Security
Screws with drive bit
(included)
14 Gauge Marine
Grade 316 Stainless
Steel Faceplate
10.14"
3.69"
5.22"
- OR -
B. Changing the Directory
Paper Directory
Directory
Lens
C. Wiring
Color Function
Black Power In
Black Power In
Green Phone Line In
Red Phone Line In
Brown Door Strike Relay common
Orange Door Strike Relay NC
Yellow Door Strike Relay NO
Blue Camera Relay common
Violet Camera Relay NC
White Camera Relay NO
The K-1275 is designed to be installed in a sheltered location, and is not meant to be used outdoors. For outdoor
applications use the can either be installed as a flush mount unit using the includedK-1275-EWP. The K-1275
rough in box, or as a surface mount unit using an optional . The rough in box uses the inner set of fourVE-5x10
holes on the face plate while the uses the outside set of holes. A set of dummy screws and nuts areVE-5x10
provided to fill the unused mounting holes.
To install a directory, remove the four screws that mount
the directory lens to the front of the using theK-1275
included Allen wrench. Insert a paper directory behind the
lens and secure the two back onto the front panel being
careful to align the names with the front panel graphics.
For your convenience, the back of this document has pre-
printed directory forms.
Note: To print directory forms for the , go toK-1275
www.vikingelectronics.com and enter “930” in the DOD
field at the top of the page for a direct link to the PDF.
The K-1275 can be powered from any source supplying 12
to 24 volts, AC or DC. A 12 volt DC adapter is supplied with
the product. When using the included adapter, the plug on
the adapter cord will have to be removed. The power
connections to the (black wires) are not polarityK-1275
sensitive.
There are also 8 more wires connected to the K-1275
controller board. Two wires are for the incoming phone line,
three are from the high current door strike relay and the last
three are from the camera relay. Gel filled butt connectors
are provided for easier connection to building wiring. The
table at the right describes each wire’s function.
3
Tuotetiedot
| Merkki: | Viking |
| Kategoria: | Kulunvalvontajärjestelmä |
| Malli: | K-1275 |
Tarvitsetko apua?
Jos tarvitset apua merkille Viking K-1275 esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Kulunvalvontajärjestelmä Viking Käyttöohjeet
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
Viking Käyttöohjeet
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024