Ventev TW-HCEN-FL-TBAR Käyttöohje

Ventev Ei luokiteltu TW-HCEN-FL-TBAR

Lue alta 📖 käyttöohje suomeksi merkille Ventev TW-HCEN-FL-TBAR (3 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 3 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä

Sivu 1/3
www.ventevinfra.com sales@ventev.com 1-800-851-4965
Flush Mount Hard Cap Wi-Fi Enclosure
Assembly Instructions
Step 1 - Cut a hole into the ceiling as shown in Figure 1. It ers so the lid covers the hole. is important to chamfer the corn
Figure 2
Step 2 - Place the enclosure base into the hole and tighten the 4 screws that clamp the enclosure to the ceiling. Knock outs
are provided to run the RJ45 cable into the enclosure. Shown in Figure 2.
Figure 1
Figure 2
www.ventevinfra.com sales@ventev.com 1-800-851-4965
Flush Mount Hard Cap Wi-Fi Enclosure
Assembly Instructions
Step 3 - Remove the back plate from the enclosure base by removing 4 screws and install the AP to it.
Step 3A - To attach Cisco AP’s, use the key holes provided and place the locking spring pin in the key hole to prevent the AP
from sliding o as shown in Figure 3 and Figure 4. Connect the RJ45 cable to the AP.
Step 3B - To attach Aruba AP’s, insert the ing spring pin in the center hole to preAP feet into the cut outs and place the lock -
vent the AP from sliding o as shown in Figure 5. Connect the RJ45 cable to the AP.
Figure 3 - Cisco
Figure 5 -Aruba
Figure 4 - Cisco
Step 3C - If you are using the Solution that includes a T-Bar, Please follow your AP Manufacturer’s Instructions to attach the
AP T-Bar Mounting Solution to the T-Bar inside the enclosure as shown in Figure 6. Connect the RJ45 cable to the AP.
Figure 6 -T-Bar
www.ventevinfra.com sales@ventev.com 1-800-851-4965
Flush Mount Hard Cap Wi-Fi Enclosure
Assembly Instructions
Step 4 - Screw the back plate back into place to the stand os provided in the base as shown in Figure 7.
Figure 9 Figure 8
Figure 10
Step 6 - To access the AP, pull the cover down and press the spring pin in to remove the cover.
Step 5 - Align the 2 spring pins on the lid assembly into the slots in the enclosure base. Push the lid towards the assembly
keeping the lid level until the cover is tight against the ceiling shown in Figures 8, 9, and 10.
Figure 7

Tuotetiedot

Merkki: Ventev
Kategoria: Ei luokiteltu
Malli: TW-HCEN-FL-TBAR

Tarvitsetko apua?

Jos tarvitset apua merkille Ventev TW-HCEN-FL-TBAR esitä kysymys alla ja muut käyttäjät vastaavat sinulle




Ei luokiteltu Ventev Käyttöohjeet

Ei luokiteltu Käyttöohjeet

Viimeisimmät Ei luokiteltu Käyttöohjeet