Getac CA-NF22 Käyttöohje
Lue alta 📖 käyttöohje suomeksi merkille Getac CA-NF22 (4 sivua) kategoriassa Kamera. Tämä opas oli hyödyllinen 2 henkilölle ja sai 4.5 tähden keskimäärin 2 käyttäjältä
Sivu 1/4
GETAC VIDEO SOLUTION
CA-NF22 Dual Lens IP Camera
QUICK START GUIDE
1. Unpacking
IP Camera
CA-NF22
Accessories
Windshield Mounting Kit
Mounting arm and
hex socket cap screw
Mounting plate, pad,
and screw x 2
2. Identifying Components
Front
No. Description
FHD Camera Lens
Status LED: It can be configured to light
up when the system is recording with
different intensities.
FHD Camera Lens: Rotatable
Rear
No. Description
Factory Reset
Status LED Red: Boot up
Green: Ready
Microphone
Top
No. Description
PoE Connector
561890690001 R00
3. Cautions and Notices
Notices
• The sale of this product is controlled by the National Defense Authorization
Act (NDAA), H.R. 5515.
• The camera must be professionally installed.
• Do not twist, squash, or bend the PoE cable (supplied separately).
• See Installation Diagram for more information.
Cautions
• Do not expose your skin to the camera when operating it in a very hot or cold
environment.
• The camera can get uncomfortably warm when you use it in high temperatures.
As a safety precaution in such a circumstance, do not touch it with your bare
hands for extended periods of time. Prolonged contact can cause discomfort
and potentially a burn.
• The camera may become very warm during normal use. It complies with the
user-accessible surface temperature limits defined by the International
Standards for Safety. Still, sustained contact with warm surfaces for long
periods of time may cause discomfort or injury
• If the camera is used for long periods, its surface can become very warm.
While the temperature may not feel hot to the touch, if you maintain physical
contact with the camera for a long time, for example if you touch it with your
bare hands, your skin might suffer a low-heat injury.
FCC Regulations
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
To assure continued compliance, follow the attached installation instructions
and do not make any unauthorized modifications.
FCC Note:
This equipment has been tested and found to comply with the limits for a
class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
Warning:
To assure continued FCC emission limit compliance, the user must only use
shielded interface cables when connecting to external units. Also, any
unauthorized changes or modifications to this equipment could void the
user’s authority to operate this device.
Tuotetiedot
| Merkki: | Getac |
| Kategoria: | Kamera |
| Malli: | CA-NF22 |
Tarvitsetko apua?
Jos tarvitset apua merkille Getac CA-NF22 esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Kamera Getac Käyttöohjeet
17 Lokakuuta 2024
17 Lokakuuta 2024
17 Lokakuuta 2024
Kamera Käyttöohjeet
- Kamera Kogan
- Kamera Kodak
- Kamera Aplic
- Kamera UniView
- Kamera Minolta
- Kamera Elmo
- Kamera Linhof
- Kamera Imou
Viimeisimmät Kamera Käyttöohjeet
25 Lokakuuta 2024
21 Lokakuuta 2024
21 Lokakuuta 2024
18 Lokakuuta 2024
18 Lokakuuta 2024
18 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024
16 Lokakuuta 2024